Rapid-air SMART MINI-SERVO FEED: SMS2, SMS4, SMS8 Manual de usuario

1RAPID-AIR CORPORATION4601 KISHWAUKEE ST. • ROCKFORD, IL 61109-2925Phone: (815) 397-2578 • Fax: (815) 398-3887 • Web Site: www.rapidair.comsmart min

10ProGramminG ProCedUre (ContinUed)F2, reset totals, on the “SET COUN-TER VALUES” screen resets the total counter to 000000. F6, exit, will return to

110.1.2.3.4.5.6.7 (not flashing)7.89Ab.cE.F.IHh or h.IJJ. oº.P. (.flashing)P. (.steady)r•S--.=S1•troUbleshootinGDisplay DescriptionInternal communic

12There are two CAN LEDs , the left LED shows activity on the CAN1 (CANopen) bus. The right LED shows activity on the CAN2 (Baldor CAN) bus. Each LED

13led statUs symbolsSymbol DescriptionDrive / comms watchdog. Internal communications failure. Clear the error; if the problem persists then conta

14led statUs symbols (ContinUed)Symbol DescriptionPower base not ready. This error condition applies only to 3-phase models. These drives have a p

15led statUs symbols (ContinUed)Symbol DescriptionPreset trapezoidal move active (in motion).DB Overload. The regeneration resistor (Dynamic Brake

16SMS - Feed

17SMS - Servo Feed

18SMS Control Panel Assembly

19SMS Wiring Schematic

2INTRODUCTION, INSTALLATION AND SET-UP ... pg. 3ADJUSTMENT, CABLING

20ALL SALES BY THE COMPANY ARE MADE SUBJECT TO THE FOLLOWING TERMS AND CONDITIONS. PLEASE READ.WARRANTY – The Company warrants, for a period of one

3The Rapid-Air Servo Feed system carries with it the quality and reliabil-ity you have grown to expect from a Rapid-Air product. The motion control s

4Every servo feed has an eccentric adjustment screw to adjust the upper roller to be in parallel to the lower roller. The maximum adjustment is .008”

5Now that your servo is in place, and the cables have been attached, you can proceed with testing the unit. The first step is to turn on the main swit

6No power indicationNo display on operators consolePower on – no motionMaterial will not enter rollsMaterial will not feedMaterial feeds shortMateria

7Problem Cause RemedytroUbleshootinG (ContinUed)Material feeds off ce

8Operator Interface Terminal ProGramminG ProCedUreThis section is to familiarize an opera-tor with the terminal screen (program) flow. Also, the secti

9ProGramminG ProCedUre (ContinUed)A VALID JOB # MUSTBE ACTIVE TO GO ONGO TO JOB ENTER SCRN JOB SCRN F6=EXITSECTION 2 F2 - MANUAL MODEPressing F2,